Toyota Tundra Hybrid (i-FORCE MAX) Tires: Load Ratings, Sizes and Towing Tips

The Tundra’s i-FORCE MAX hybrid adds an electric motor and battery to the twin-turbo V6, which brings more torque and more weight. Tires for the hybrid truck are the same sizes as the gas Tundra, but the extra mass and torque make load ratings, pressures and rotation more important. Here is what owners should know.

Quick Answer

The Tundra i-FORCE MAX uses the same factory sizes as other third-generation Tundras, such as 265/70R18, 265/60R20, 265/50R22 and 285/65R18 on off-road grades. KBB lists the hybrid CrewMax at 5,710 to 6,185 lb, and the 2026 hybrid tows up to 11,450 lb. Replacement tires must meet the placard load index; for regular heavy towing, consider LT (Load Range E) tires.

Key Takeaways

  • The i-FORCE MAX makes 437 hp and 583 lb-ft, so tread on the rear tires works hard.
  • Hybrid CrewMax curb weights run about 5,710-6,185 lb, heavier than comparable gas trucks.
  • Never fit a tire with a lower load index than the placard specifies.
  • Toyota’s recall work instructions list 97 ft-lbf (131 N·m) for Tundra wheel nuts.

How the Hybrid Changes Tire Demands

pickup truck rear tire and wheel while towing a trailer

Toyota rates the i-FORCE MAX at 437 horsepower and 583 lb-ft of torque, with peak torque arriving at 2,400 rpm. KBB lists the 2025 Tundra i-FORCE MAX CrewMax at 5,710 to 6,185 pounds. One Toyota dealer notes that the 2026 hybrid tows up to 11,450 pounds, slightly less than the gas truck’s 12,000-pound maximum, because the motor and battery add weight within the same weight ratings.

Factor What it means for tires
More curb weight Less margin before reaching the tire’s load capacity
High low-rpm torque Faster wear on rear tires with hard launches or towing
Towing and payload Pressure and load index matter more than tread style

Products Worth Considering

Tundra Hybrid Tire Sizes

Third-generation Tundras share sizes across gas and hybrid trucks. Toyota’s 2024 recall documents for Tundra and Sequoia Hybrid list factory tires in 265/70R18, 265/60R20, 265/50R22 and 285/65R18. Trim and package decide which you have, so confirm the size and load index on the door placard. Our 3rd-gen Tundra tire size chart lists sizes by trim, and TRD Pro owners can see the TRD Pro tire guide.

Note: The 2024 sidewall-damage recall (24V-767) included Tundra Hybrid trucks. See our Tundra tire recalls page to check whether yours is affected.

Choosing Tires for a Hybrid Tundra

  1. Start with the placard: match size, load index and speed rating or exceed them.
  2. If you tow near the limit or carry heavy payloads often, consider LT (Load Range E) tires, and inflate to the pressure the vehicle and tire maker specify for the load.
  3. For mostly highway use, a highway-terrain tire saves fuel and runs quieter, which you notice in a hybrid.
  4. For gravel, snow or trails, an all-terrain with the three-peak mountain snowflake gives year-round grip.
  5. Keep all four tires the same make, model and tread depth for consistent traction control behavior.

Warning: LT tires often need different pressures from passenger tires. Ask the installer to set pressures for your load and confirm the TPMS warning threshold suits the new setup.

Products Worth Considering

Pressure, Rotation and Torque

  • Check pressures cold before towing; heat from towing raises readings.
  • Rotate every 5,000 miles, or sooner if you tow often, to even out rear wear.
  • Torque wheel nuts to 97 ft-lbf (131 N·m), the figure in Toyota’s Tundra recall work instructions, and re-check after 50-100 miles.
  • Watch for rubbing if you fit larger tires; see Tundra tire rubbing.

Frequently Asked Questions

Does the Tundra Hybrid use different tires from the gas Tundra?

No. Both use the same factory sizes for a given trim. The hybrid is heavier, so make sure replacement tires meet the placard load index.

How much does the Tundra i-FORCE MAX weigh?

KBB lists the 2025 Tundra i-FORCE MAX CrewMax at 5,710 to 6,185 pounds, depending on configuration.

How much can the Tundra Hybrid tow?

A Toyota dealer lists up to 11,450 pounds for the 2026 i-FORCE MAX when properly equipped, compared with 12,000 pounds for the gas truck.

Should I use LT tires on a Tundra Hybrid?

If you tow or haul heavy loads often, LT (Load Range E) tires add capacity and sidewall strength. For mostly unloaded driving, passenger-rated tires that meet the placard are suitable.

Sources

  1. KBB: 2025 Toyota Tundra i-FORCE MAX CrewMax
  2. North Hollywood Toyota: Tundra i-FORCE MAX vs i-FORCE towing
  3. Toyota 2026 Tundra eBrochure
  4. Toyota recall 24V-767 part list
  5. Toyota technical instructions, recall 24TA12

Products Worth Considering

Sharing Is Caring:
About the Author

Cole Mitchell

Cole Mitchell is TubeTyre's Toyota SUV and truck tire specialist, covering the RAV4, Tacoma, 4Runner and Hyundai Sonata in depth. His work focuses on fitment and plus-sizing, tire pressure and rotation schedules, alignment and vibration troubleshooting, and seasonal tire choices for daily drivers. Cole also contributes maintenance, safety and performance guides that explain how tire choice changes handling, braking and ride comfort on the road.

Leave a Comment

Your email address will not be published. Required fields are marked *